CG Gurus,
Receiving the attached error when attempting to drop a control on a CGWizard Step. Only by massaging the dfm file am I able to properly assign the control in design time.
Please Advise.
Monte Carver
Error: Only steps are accepted inside Wizard
2 posts
• Page 1 of 1
You do not have the required permissions to view the files attached to this post.
- mrcarver
- Posts: 70
- Joined: 05 Jun 2012 10:51
Hi mrcarver,
This problem is already detected and fixed in 4.0.1.105.
Thank you.
Best Regards.
This problem is already detected and fixed in 4.0.1.105.
Thank you.
Best Regards.
Group: Developers | Support Team
- info [at] cgdevtools.com - General information
- sales [at] cgdevtools.com - Sales department
- support [at] cgdevtools.com - Product and Technical Support
-
Alexander Bulei - Site Admin
- Posts: 3635
- Joined: 15 May 2012 08:52
- Location: Mealhada, Portugal
2 posts
• Page 1 of 1