Jquery versions

[bzwirs]

New to JQuery.

I notice that there are versions available for download for the various versions of Intraweb. Are your versions backwards compatible or do I need to download the version for the specific Intraweb version?

regards

Bill Zwirs

[Jorge Sousa]

Welcome Bill!

Yes you need to download by Intraweb version. You have a older version?

[bzwirs]

Version 12.1.27. Recently purchased and installed.

regards

Bill Zwirs

[Jorge Sousa]

Bill

You must download our setup for 12.1.26 because its compatible with 12.1.27

The problem here is that Atozed removed that version from their site, so we no longer have access to it to make our version build.

As you can see in http://www.atozed.com/IntraWeb/Download/Download.EN.aspx

We advise to use 12.2.4, because is much more faster than 12.1.27

Regards

cgdevtools

[bzwirs]

Ok. Downloaded and installed Intraweb 12.2.4 but that seemed to have issues with the TMS Intraweb components that are installed so have uninstalled and gone back to Intraweb 12.1.27. My current project wich currently has the TMS components compiled and ran with no problems. Downloaded and installed the JQuery components for 12.1.26 (as advised) and after install I now get the following error message when starting XE2.

The procedure entry point
@Iw@Httpreply@THttpreply@WriteString$qqrx20System@UnicodeString
could not be located in dynamic link library Intraweb_120_160.bpl

followed by the error

Can't load package C:\Program Files\CGComponents\RS16\lib\Win32\release\dclIWCGJQComps_120-160.bpl

Any clues as to why I should now get those messages.

regards

Bill Zwirs

[Jorge Sousa]

Bill, if you installed 12.2.4 Intraweb version you must download our version for 12.2.4 version and not 12.1.26.

So, try this one please http://www.cgdevtools.com/wp-content/plugins/download-monitor/download.php?id=13.

If you go back to 12.1.27 please uninstall and install again 12.1.26

And give us feedback please.

[bzwirs]

Yes I did download and install 12.2.4 but that had issues with the TMS Intraweb components...in particular their grid. I am assuming this is to do with the TMS and Intraweb version 12.2.4 compatibility.

I uninstalled all that and reinstalled Intraweb 12.1.27 and JQuery components for 12.1.26. This is where I now get the error messages described in my earlier post.

regards

Bill Zwirs

[Jorge Sousa]

Hi Bill

Did you uninstalled jQuery Components for 12.2.4?

You have to uninstall 12.2.4 and then install 12.1.26

Unless Intraweb 12.1.27 is different in public declarations with Intraweb 12.1.26, that should work.

You're going to try install our 12.1.26 with Intraweb 12.1.27, to see if anything goest wrong

Regards

[Jorge Sousa]

Bill

We already contacted Atozed

And nobody seems to know about 12.1.27

So if you don't mind please send us a link to where we can download that misterious version, so that we can build our version based on IW's version

Thanks

[Jorge Sousa]

Bill

I've further information about 12.1.27

That version is broken, and was deleted

About

"Intraweb 12.2.4 but that seemed to have issues with the TMS Intraweb components "

Can you detail this? Because that not what I've been experienced.

Regards

Pedro