CGDevTools Forum

Hi

I have a TIWCGJQTabs with two tabs.
On the second tab i have a OnSelect eventhandler.

I expected it to fire when i select that tab.

It does not.

When should it fire?

Eric

Hello,

I'm sure, you are using JQEvents, but you can't.
You need use the JQTabOptions.OnSelect event.

Best Regards.

Hi

>>I'm sure, you are using JQEvents, but you can't.

Why are they published properties?

Eric

Hi


Ok i now set the RowNum on the Select:

Code: Select all

  if IWCGJQTabsUserMain.ActiveTab = IWCGTabServices then
  begin
    GridProfile.JQGridOptions.RowNum := UserSession.IMSession.RowNum;
    ReloadGrid(GridProfile);
    btnExportProfile.Enabled := (GridProfile.JQGridProviderCells.Rows.Count > 0);
  end
  else if IWCGJQTabsUserMain.ActiveTab = IWCGTabRequests then
  begin
    GridOrderItems.JQGridOptions.RowNum := UserSession.IMSession.RowNum;
    ReloadGrid(GridOrderItems);
    btnExportProfile.Enabled := (GridOrderItems.JQGridProviderCells.Rows.Count > 0);
  end;
end;


The numbers of Rows shown is correct (5) only not the number shown in the Pager (still 25)

Eric